CureZone   Log On   Join
Re: I've built my own single 9V dc beck's blood cleaner
Gill Grabber Views: 70,607
Published: 14 years ago
This is a reply to # 1,462,991

Re: I've built my own single 9V dc beck's blood cleaner

"i can only find 2.3 meg ohm o.6 watt 5% resistor is this ok. i also wonder if the resistor in the top left is R150 or is it ment to be 150k, same with the R820?"

the 2.3meg .6Watt is fine, but it will be bit larger to fit elegantly in to this type of layout. You can get around that by giving your circuit board extra line between the LM358 and NJU7660D to fit this larger resistor.

The top left corner of the schematic is a 150 ohm resistor used on the Colloidal Silver circuit.

The R820 is also just 820 ohm resistor.

I just found mistake in my diagram - with the two 18V Zenner Diodes - the lower diode should connect opposite to the first diode from pin 7 on the LM358. The first diode the bar on it will face the LM358, the second one - its band will face the LED. I will update the excel file. //

This actual component diagram is based of this circuit:

Printer-friendly version of this page Email this message to a friend
Alert Moderators
Report Spam or bad message  Alert Moderators on This GOOD Message

This Forum message belongs to a larger discussion thread. See the complete thread below. You can reply to this message!


Donate to CureZone

CureZone Newsletter is distributed in partnership with

Contact Us - Advertise - Stats

Copyright 1999 - 2023

14.547 sec, (1)