CureZone   Log On   Join
Re: I've built my own single 9V dc beck's blood cleaner
gozoo1 Views: 70,749
Published: 14 years ago
This is a reply to # 1,467,668

Re: I've built my own single 9V dc beck's blood cleaner

This is really weird, everytime i test the circuit i get a different test reading on the volt meter,i just put a link between the 3rd rectifier down and the + bus bar and then tested all the readings on them and it seemed to be correct as i went to through them the voltages went up to 34v at the top 1, i took it off and then tried it again to double and i just wasnt the same, i tried again quite a few times but still i didnt get that test result again, is there a link missing from your diagram, or do you thunk i have a faulty component somewhere, there is nothing loose i have checked everywhere, i want to ask, if i was to start again ,is there any way i can check and test it as i go along whilst putting each component in place, if so then please tell me what is the procedure.

kindest regards


Printer-friendly version of this page Email this message to a friend
Alert Moderators
Report Spam or bad message  Alert Moderators on This GOOD Message

This Forum message belongs to a larger discussion thread. See the complete thread below. You can reply to this message!


Donate to CureZone

CureZone Newsletter is distributed in partnership with

Contact Us - Advertise - Stats

Copyright 1999 - 2023

2.719 sec, (1)